Subject: |
RE: Problem with MVME167-02B boards |
From: |
Mark Rivers <[email protected]> |
Date: |
Wed, 24 May 1995 15:18:50 -0500 (CDT) |
Re: my previous message:
> I just got two new Motorola MVEME167-02B boards. I installed the vxWorks 5.1
> ROMs and tried swapping them into an IOC in place of an old MVME167. vxWorks
> boots and EPICS starts, but there is one huge problem: no VME A16 devices are
> visible. If I put the old MVME167 back in it works fine. With the new board
> all non-VME devices work fine, but no VME A16 addresses respond.
It was a silly mistake. I had also installed an MV162 board to run HiDEOS and
had left an empty slot in the VME backplane. Everything is fine now. Thanks
to John Winans!
Mark Rivers
- Navigate by Date:
- Prev:
Re: Postscript Documentation Andrew Johnson
- Next:
Re: Postscript Documentation Tim Mooney
- Index:
1994
<1995>
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
- Navigate by Thread:
- Prev:
Problem with MVME167-02B boards Mark Rivers
- Next:
Re: Postscript Documentation, Whoops! Tim Mooney
- Index:
1994
<1995>
1996
1997
1998
1999
2000
2001
2002
2003
2004
2005
2006
2007
2008
2009
2010
2011
2012
2013
2014
2015
2016
2017
2018
2019
2020
2021
2022
2023
2024
|