Experimental Physics and
Industrial Control System

Bob writes:
>  My memory is not great, but I seem to remember something about the end 
>  of move interrupt not working. That would be the lowest latency response. 
>  If someone checks that out and determines that it works, let me know so that 
>  we can incorporate it immediately, thanks.
>   

The "end of move" interrupt on the OMS VME8 and VME44 seems to work fine. 
I tested older versions of these boards and did not see a problem.
Steve Flago of OMS remembers fixing "end of move" interrupt problems  
years ago. 

	Joe

Navigate by Date:

Prev: [none given] cleaves%mickey.UUCP%denali.UUCP

Next: [none given] Jeff Hill

Index: <1994>  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024 

Navigate by Thread:

Prev: Re: OMS VME-8 motor controllers: PAL upgrades Joseph P. Sullivan

Next: Re: CA problem from Vax Jeff Hill

Index: <1994>  1995  1996  1997  1998  1999  2000  2001  2002  2003  2004  2005  2006  2007  2008  2009  2010  2011  2012  2013  2014  2015  2016  2017  2018  2019  2020  2021  2022  2023  2024