Mechanical Engineering & Design

Policy and Procedure

Front End Procedures

Canted Undulator

Procedure for Installing wall collimator for the Canted Undulator Front End

Canted Undulator Front End 1st and 2nd Photon Shutter hard stop and position sensing switch setting procedure

1st and 2nd Canted Undulator Photon Shutter Position Switch Setting Procedure

Canted Undulator Safety Shutter Tungsten Installation Procedure

High Heat Load Front End

Front End Safety Shutter Position Sensing Switch Setting Procedure

BM FE Vs. 2.0
Version 2.0 BM Photon Shutter Switch Setting Procedure

Beamline Shutter Procedures

2BM Pink / Mono Shutter Position Sensing Switch Setting Procedure

Insertion Device Vacuum Chamber Procedures

Assembly and Certification of 2.5 & 5M Insertion Device Vacuum Chamber

Installation Procedures

Drilling holes in a concrete floor in the experimental hall at APS

Front End Installation Procedure
Under review